2外設(shè)控制器 CY7C63723C-SXC Cypress Semiconductor - enCoRe USB Combination Low-Speed USB & PS/2 Peripheral Controller
Features
• enCoRe™ USB - enhanced Component Reduction
—Internal oscillator eliminates the need for an external crystal or resonator
—Interface can auto-configure to operate as PS/2 or USB without the need for external components to switch between
modes (no GPIO pins needed to manage dual mode capability)
—Internal 3.3V regulator for USB pull-up resistor
—Configurable GPIO for real-world interface without external components
• Flexible, cost-effective solution for applications that combine PS/2 and low-speed USB, such as mice, gamepads,
joysticks, and many others.
• USB Specification Compliance
—Conforms to USB Specification, Version 2.0
—Conforms to USB HID Specification, Version 1.1
—Supports 1 Low-Speed USB device address and 3 data endpoints
—Integrated USB transceiver
—3.3V regulated output for USB pull-up resistor
• 8-bit RISC microcontroller
—Harvard architecture
—6-MHz external ceramic resonator or internal clock mode
—12-MHz internal CPU clock
—Internal memory
—256 bytes of RAM
—8 Kbytes of EPROM
—Interface can auto-configure to operate as PS/2 or USB
—No external components for switching between PS/2 and USB modes—No GPIO pins needed to manage dual mode capability
• I/O ports
—Up to 16 versatile General Purpose I/O (GPIO) pins, individually configurable
—High current drive on any GPIO pin: 50 mA/pin current sink
—Each GPIO pin supports high-impedance inputs, internal pull-ups, open drain outputs or traditional CMOS outputs
—Maskable interrupts on all I/O pins
• SPI serial communication block
—Master or slave operation
—2 Mbit/s transfers
• Four 8-bit Input Capture registers
—Two registers each for two input pins
—Capture timer setting with 5 prescaler settings
—Separate registers for rising and falling edge capture
—Simplifies interface to RF inputs for wireless applications
• Internal low-power wake-up timer during suspend mode
—Periodic wake-up with no external components
• Optional 6-MHz internal oscillator mode
—Allows fast start-up from suspend mode
• Watchdog Reset (WDR)
• Low-voltage Reset at 3.75V
• Internal brown-out reset for suspend mode
• Improved output drivers to reduce EMI
• Operating voltage from 4.0V to 5.5VDC
• Operating temperature from 0 to 70 degrees Celsius
• CY7C63723 available in 18-pin SOIC, 18-pin PDIP
• CY7C63743 available in 24-pin SOIC, 24-pin PDIP
• CY7C63722 available in DIE form
• Industry standard programmer support
